1926.302(b)

Pneumatic power tools.

1926.302(b)(1)

Pneumatic power tools shall be secured to the hose or whip by some positive means to prevent the tool from becoming accidentally disconnected.

1926.302(b)(4)

Compressed air shall not be used for cleaning purposes except where reduced to less than 30 p.s.i. and then only with effective chip guarding and personal protective equipment which meets the requirements of Subpart E of this part. The 30 p.s.i. requirement does not apply for concrete form, mill scale and similar cleaning purposes.

Click here for product specific data concerning maximum incoming line pressures and static output pressures.

1926.302(b)(5)

The manufacturer's safe operating pressure for hoses, pipes, valves, filters, and other fittings shall not be exceeded.

Click here for product specific data concerning maximum incoming line pressures and static output pressures.

1926.302(b)(7)

All hoses exceeding 1/2-inch inside diameter shall have a safety device at the source of supply or branch line to reduce pressure in case of hose failure.